Titan M150 Osmosis Epoxy Primer

Titan M150 Osmosis Epoxy Primer is a two component epoxy primer specially formulated for preventive treatment of osmosis. High antioxidant primer layer thickness on iron and aluminum. Especially for submerged surfaces.

Or submerged surfaces in marine environments that require a high layer thickness, previously primed with epoxy primer Antioxidant Titan Yate.

Technical Characteristics

• Size: 750ml & 4Lt
• Gray
• Finish: Semi-gloss
• Yield: 5-7 m2 / l (120-160 μ) per coat
• Drying at 23 ° C 60% RH: 8 hours
• Repainting 60% RH at 23 ° C: 20 - 24 hours
• Mixing ratio: Base: 4 Hardener: 1
• Pot Life at 23 ° C: 8 hours
• Thickness Recommended: Immersion service: 450 μ
• Tools: brush, roller or spray
• Thinner: Epoxy Thinner
• Cleaning of tools: Thinner Epoxy

General Recommendations:

Remove the container well. The surfaces must be clean, dry and degreased.

Unprepared Surfaces

Polyester: Osmosis treatment must eliminate the gel-coat, providing roughness to the surface, rinse with fresh water and let dry thoroughly. Apply 1 coat of epoxy primer yacht Titan M150 Thick diluted with 15% Thinner Titan Yate. Let dry for 24 hours, putty if necessary with Epoxy Putty TITAN yacht, and finish 3-4 layers of epoxy primer Titan M150 Thick Yate.

Iron and aluminum: deoxidation and apply 1 coat of epoxy primer Titan yacht after 24 hours, apply 3 coats of epoxy primer Titan M150 Thick Yate.

In all cases, after more than 3 days sanding is required.

Maintenance painted surfaces in poor condition: Remove completely with Paint Stripper, followed by washing with fresh water and proceed as in unpainted surface.